Categories
Instructions for the use of auto show balls
Instructions for the use of auto show balls
Nov 14th,2025
101 Views
Installation and precautions:
1. Adjust the position of the auto show ball, usually the zipper is on the side, not directly at the audience. The side with the fan mouth is placed at the back, so that guests can't see the fan.
2. Spread the auto show ball out, spread the bottom flat, and press wooden boards and sandbags around it (the function is that the bottom is flat when it is full of air, so that the edge will not become warped).
3. Drive the vehicle onto the bottom surface of the ball, and pay attention to slightly cushion the zipper to prevent the wheel from crushing the zipper.
4. Pull the zipper along one end, stick the cover with burr in the middle, and hang the rope behind the ball.
5. Tie the fan firmly to the fan mouth, plug it in, and the fan starts to blow. Pay attention to the fact that there are no paper scraps and sundries that are easy to inhale around the fan, so as not to block the air inlet of the fan.
6. When the ball is full, in order to avoid excessive internal pressure and blow the ball, you can properly unzip the zipper for a small mouth, but you must ensure that the ball has a certain pressure.
7. If there is a car model in the car, you can let the car model enter the car from the zipper mouth in advance, because the fan keeps blowing, so you don't have to worry about the air exchange inside.
8. If you want to fly small balloons, you can put helium balloons (don't use hydrogen balloons, it's too dangerous) into the ball from the zipper, and it will be good to put about 300-500 balloons.
9. At the beginning of the activity, the lights are dimmed, and the projection can be cast on the spherical surface to change various colors and patterns.
10. At the climax of the activity, count down to 5. At 1 o'clock, the installer will pull down the rope from behind instantly, and the ball will explode instantly. At this time, the cold fireworks, colorful flowers and balloons will be released together, the car model will turn on the car engine, the lights will be turned on, the motor will roar, and the car model will slowly get out of the car and set up the POSS, and the whole new car release will be completed successfully.
The auto show ball makes the whole new car release full of mystery and layering!
