Categories
Matters needing attention in back modeling
Matters needing attention in back modeling
Nov 14th,2025
112 Views
1. Open the packaging bag and lay the shape on a clean floor.
2. Zip the back and take out the fan connector wire.
3. Put on the back shape and connect the waist belt.
4. Put the battery in the battery bag on the belt, with the side with the interface facing up.
5. Connect the connector of the fan to the power supply of the battery. Note that the red line is connected to the red line and the black line is connected to the black line. When connecting, hold the transparent rubber head and insert it together.
6. The fan can be full in 1-2 minutes, and you can perform various performances by adjusting the strap to the best position.
7. After the performance, separate the plug of the battery and the fan. Be careful to hold the transparent rubber head together when pulling out the plug.
8. Then open the zipper on the back, spread it on a clean floor, and roll it from the opposite side of the zipper after it is laid neatly. After the air is pressed out, the packaging volume can be reduced.
9. Charge the battery in time after using it to protect its service life. If the battery is not used, it should be discharged and charged once a week to prolong the battery life. Be sure to fully charge the battery before storing it.
